Compensation Method for Temperature Distribution Measured by Infrared Thermography for Non-flat Surfaces
-
摘要: 利用红外热像仪测温需先设定被测表面的法向发射率,该发射率通常为定值。而当热像仪处于被测点的天顶角大于50°的位置范围时,由于被测点定向发射率的变化,必造成这些点的测温误差。对于非平表面,这样的点大量存在。因此,必须对其测温结果进行修正。本文针对使用单目红外热像仪测量非平表面温度时由于各点定向发射率的变化引起的测量误差进行研究,并依据物体表面定量发射率的变化规律,给出了测量点的温度修正系数。同时,通过点云三维建模,利用热像仪的几何成像原理推导出红外热像图与实际被测表面中点与点的对应关系,给出了通过红外热像仪测量非平表面的温度分布的误差修正方法。实验证明了该方法的有效性。Abstract: When employing an infrared thermal imager to measure surface temperature, the emissivity of the surface to be measured should be set first and kept constant during the measurement process. However, when the infrared imager is placed in the range of more than 50° of the zenith angle of the points to be measured, the emissivities of the points in this angle will vary significantly; hence, temperature measurement errors will occur, especially for points on non-flat surfaces. In view of the measurement error caused by the variation of emissivity of different points in the measured non-flat surface when using a monocular infrared thermal imager, this paper provides a compensation factor based on the variation rules of the emissivity with the measuring angle. In addition, based on 3D modeling technology, the relationship between the positions of the points in the thermographic image and those in the actual surface is determined. The compensation method of the temperature measurements for a non-flat surface is presented. The feasibility of the method was verified through experiments.
-
表 1 材料各波段复折射率
Table 1. Complex refractive indexes of the materials in each wave bands
Al Brass PS PE band/μm 3-5 8-13 3-5 8-13 3-13 3-13 n 6.62 23.19 4.77 17.21 1.57 1.52 k 37.77 85.04 23.73 51.85 0 0 -
[1] 杨立, 杨桢. 红外热成像测温原理与技术[M]. 北京: 科学出版社, 2016.YANG Li, YANG Zhen. Theory and Technology of Temperature Measurement by Infrared Thermography[M]. Beijing: Beijing Science Press, 2016. [2] 范春利. 几何形状导热反问题方法与应用[M]. 北京: 科学出版社, 2015.FAN Chunli. Geometric Inverse Heat Conduction Problems: Methods and Applications[M]. Beijing: Science Press, 2015. [3] 廖盼盼, 张佳民. 红外测温精度的影响因素及补偿方法的研究[J]. 红外技术, 2017, 39(2): 173-177. http://hwjs.nvir.cn/article/id/hwjs201702012LIAO Panpan, ZHANG Jiamin. Research on influence factors for measuring and method of correction in infrared thermometer[J]. Infrared Technology, 2017, 39(2): 173-177. http://hwjs.nvir.cn/article/id/hwjs201702012 [4] 刘慧开, 杨立. 太阳辐射对红外热像仪测温误差的影响[J]. 红外技术, 2002, 24(1): 34-37. doi: 10.3969/j.issn.1001-8891.2002.01.010LIU Huikai, YANG Li. Effect of radiation of the sun on infrared temperature measurement[J]. Infrared Technology, 2002, 24(1): 34-37. doi: 10.3969/j.issn.1001-8891.2002.01.010 [5] 吕游, 杨波, 魏仲慧, 等. 大气与环境影响分析的红外比色测温方法[J]. 红外与激光工程, 2015, 44(8): 2321. doi: 10.3969/j.issn.1007-2276.2015.08.015LV You, YANG Bo, WEI Zhonghui, et al. Middle infrared colorimetric temperature measurement method considered influence of atmosphere and ambient[J]. Infrared and Laser Engineering, 2015, 44(8): 2321. doi: 10.3969/j.issn.1007-2276.2015.08.015 [6] 石东平, 吴超, 李孜军, 等. 基于反射温度补偿及入射温度补偿的红外测温影响分析[J]. 红外与激光工程, 2015, 44(8): 0204006. https://www.cnki.com.cn/Article/CJFDTOTAL-HWYJ201508016.htmSHI Dongping, WU Chao, LI Zijun, et al. Analysis of the influence of infrared temperature measurement based on reflected temperature compensation and incidence temperature compensation[J]. Infrared and Laser Engineering, 2015, 44(8): 0204006. https://www.cnki.com.cn/Article/CJFDTOTAL-HWYJ201508016.htm [7] 张健, 杨立, 刘慧开. 环境高温物体对红外热像仪测温误差的影响[J]. 红外技术, 2005, 27(5): 419-422. doi: 10.3969/j.issn.1001-8891.2005.05.017ZHANG Jian, YANG Li, LIU Huikai. Effect of environmental object on infrared temperature measurement[J]. Infrared Technology, 2005, 27(5): 419-422. doi: 10.3969/j.issn.1001-8891.2005.05.017 [8] 周志成, 魏旭, 谢天喜, 等. 观测距离及视角对红外热辐射检测的影响研究[J]. 红外技术, 2017, 39(1): 86-90. http://hwjs.nvir.cn/article/id/hwjs201701016ZHOU Zhicheng, WEI Xu, XIE Tianxi, et al. Influence of observation distance and angle of view on the detection accuracy of infrared thermal radiation[J]. Infrared Technology, 2017, 39(1): 86-90. http://hwjs.nvir.cn/article/id/hwjs201701016 [9] 杜玉玺, 胡振琪, 葛运航, 等. 距离对不同强度热源红外测温影响及补偿[J]. 红外技术, 2019, 41(10): 976-981. http://hwjs.nvir.cn/article/id/hwjs201910014DU Yuxi, HU Zhenqi, GE Yunhang, et al. Distance influence and compensation of infrared temperature measurement with different intensity heat sources[J]. Infrared Technology, 2019, 41(10): 976-981. http://hwjs.nvir.cn/article/id/hwjs201910014 [10] 范春利, 杨立, 华顺芳. 热探测器温度对红外热像仪测温的影响[J]. 红外技术, 2002, 24(5): 22-24. doi: 10.3969/j.issn.1001-8891.2002.05.006FAN Chunli, YANG Li, HUA Shunfang. Effect of temperature of thermal detector on temperature measurement of uncooled infrared thermography[J]. Infrared Technology, 2002, 24(5): 22-24. doi: 10.3969/j.issn.1001-8891.2002.05.006 [11] Mikhail Polyanskiy. Refractiveindex.info database[DB/OL].[2020-04-01] https://refractiveindex.info/2008-2020. [12] 马颂德, 张正友. 计算机视觉: 计算理论与算法基础[M]. 北京: 科学出版社, 1998.MA S, ZHANG Z. Computer Vision Algorithms and the Theoretical Calculation Based[M]. Beijing: Science Press, 1998. [13] ZHANG Z. A flexible new technique for camera calibration[J]. IEEE Transactions on Pattern Analysis & Machine Intelligence, 2000, 22(11): 1330-1334. http://dl.acm.org/citation.cfm?id=357025